Publicidad
Idiomas disponibles
Idiomas disponibles
• Attentions
1. Before charging, turn off the switch; during and after charging it is normal for the charger and
batteries to be slightly warm;
2. If the batteries are not used for a long time, they must be recharged every 3 months to increase
their life;
3. New or unused batteries for a long time will reach their maximum capacity after 5 charge-
discharge cycles;
4. Do not charge the batteries repeatedly after several minutes of operation. This could reduce the
working time and the effectiveness of the batteries;
5. Do not use damaged batteries and do not disassemble the charger or batteries.
6. Batteries can explode or catch fire.
7. Do not charge the batteries outdoors or in humid environments.
8. As battery power gradually decreases, it is normal for cutting diameter capacity to decrease.
9. Do not use the electric scissors while charging.
• Blade polishing
1. Turn off the tool when opening the blade, remove the battery.
2. Both sides of the movable blade are polished using the oil stone, forming the section angle with
the blade as shown in the photo;
3. After polishing the blade, clean it, insert the battery, test it, then close the blade and finish it.
EN
21
Original instructions
Publicidad
