Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Troubleshooting
Problem
Air not blasting when Air Trigger (5) is pulled
Tool will not stop after the Air Trigger is released
8
Pressure incorrect
Air blockage
Hose clogged; hoses damaged or leaking
Throttle valve O-ring or valve seat damaged
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre
Possible Cause
Solution
Set the correct air pressure according to the Specifications
Check air supply; disassemble and clean Air Tyre Inflator if
necessary
Remove rubber hose and remove blockages; check air supply
hoses and connectors and check for damage or leakages. Then
have them repaired or replaced as required
Have the tool repaired at an authorised Silverline service centre
Publicidad
