Publicidad
Idiomas disponibles
Idiomas disponibles
Usage of the kettle:
01. Select the required voltage
Select the required voltage by turning the selector control.
Always check that you have selected the correct voltage
before using the kettle. For Europe the setting is 230 V
03. Switch on the kettle
Plug in and switch on by pressing the reset button.
The neon pilot lamp will light up.
ATTENTION:
Note: should the reset button have been pressed before plugging in, the appliance will be
automatically switched on after it has been plugged in.
Note
Your kettle will boil and switch off automatically. To re-boil, the On/Off switch needs time to
reset. Let it cool down before re-filling.
– it is just condensation.
Boil-dry protection
If you switch on with too little water, your kettle will cut off automatically. Let it cool down before
re-filling.( approx. 10 Min. ) When it has cooled down, the switch will reset itself.
page 10
02. Filling the kettle
Fill it through the spout or lid. The water level must not
exceed "MAX" mark. Check the lid is closed.
04. Always unplug after use
Your kettle will boil and switch off automatically. To re-boil,
the On/Off switch needs time to reset.
Note:
Always unplug the kettle after use.
If you find drops of water under your kettle, don't worry
ATTENTION:
Pay special attention the Voltage
selector on the bottom is
switched to the correct Voltage.
You cannot use the item within
Europe if the Voltage selector is
fixed to the 120 Volt marking.
The item will get damaged
immediately.
Publicidad
