Manual Settings - TFA 60.2550 Instrucciones De Uso

TFA_No. 60.2550_Anleitung_09_18
BINGO 2.0 - Radio-controlled alarm clock
• During nighttime, the atmospheric interference is usually less severe,
and reception is possible in most cases. A single daily reception is
adequate to keep the accuracy deviation under 1 second.
7. Operation
• Press and hold – or + button in the setting mode for fast mode.
• The instrument will automatically quit the setting mode if no button
is pressed within 15 seconds.
• If the button tone is enabled, each button operation is acknowledged
with a beep.

7.1 Manual settings

• Press and hold the SET button at the back in normal mode for three
seconds.
• dcF appears on the display and ON (default) will be flashing. If the
DCF reception is activated and after successful reception of the DCF
signal no manual adjustment is necessary.
• Press the – or + button if you want to deactivate the DCF reception
(OFF).
• Confirm the setting with the SET button.
• If the DCF reception is enabled (ON), you can set the time zone after
confirmation with the SET button (TZ appears on the display and 0
default will be flashing).
26
19.09.2018 16:09 Uhr Seite 14
BINGO 2.0 - Radio-controlled alarm clock
• Press the – or + button to adjust the time zone (-9/+9).
• The time zone correction is needed for countries where the DCF sig-
nal can be received but the time zone is different from the DCF time
(e.g. +1=one hour later).
• Confirm the setting with the SET button.
• Press the SET button to make the settings in the following sequence:
the hours, the minutes, the year, the month, the day, the temperature
unit (default °C), the day-of-week language (default German), and
the button tone (default OFF). Press the – or + button to adjust it.
• Confirm the setting with the SET button.
• After a successful reception of the DCF signal, and if the DCF recep-
tion is activated (ON), the manually set time will be overwritten.
7.1.1 Setting of the temperature unit
• Press the – or + button to toggle between Celsius (°C) or Fahrenheit
(°F) as temperature unit to select.
• Confirm the setting with the SET button.
• If Fahrenheit is set, the time is automatically displayed in the 12-
hour format. AM or PM appears on the display. The date format
changes to month / day.
27