Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2.1.2. Battery installation
1) Remove the battery cover from
the back of the RS485 SETTING
TOOL.
2) Insert the batteries following the
polarity indicated.
3) Replace the battery cover on
the rear of the RS485 SETTING
TOOL.
2.1.3. Safety instructions
Warning
This product contains a cell battery.
Do not swallow the battery: risk of potentially fatal chemical burns in less
than 2 hours.
If the battery enters any part of the body or if in any doubt, call a doctor
immediately.
Keep batteries (new and used) and the product out of the reach of children. If
the battery compartment no longer closes, do not use the product and keep
out of the reach of children.
Risk of explosion, leaking flammable liquids or gases from the battery if it is
kept at a high temperature (hot oven, fire), crushed, cut or subject to very
low air pressure.
Non-rechargeable batteries must not be recharged.
Explosion risk if the battery is replaced by an incorrect type.
Never use rechargeable batteries, use only alkaline batteries.
6
Copyright
©
2020 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
1
2
3
RS485 SETTING TOOL
Publicidad
