Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000283-001.book Page 12 Wednesday, August 30, 2017 11:30 AM
Tool Specifications
Battery charger
Article number
Voltage range
Charging current, rapid charging
Charge duration with 12 V / 3.0 Ah
Charge duration with 18 V / 5.0 Ah
Weight according to
EPTA-Procedure 01
Battery type Voltage
0700 956 331
12 V
0700 913 733
18 V
0700 913 732
18 V
0700 913 734
18 V
Intended Use
The battery charger is suitable for automatic charging
and re-charging of 12 V, 18 V-LI Würth batteries.
Do not try to charge non-rechargeable batteries with
this charger.
For damage caused by usage other than intended, the
user is responsible.
Symbols
Read all safety warnings and all
instructions
Warning
Do not discard the battery into fire.
Do not charge defective batteries.
Replace defective batteries.
AL 60-12/
18-AS-LI
0700 814
12 V, 18 V
6.0 A
50 min
59 min
0.70 kg
Rated
Number of
capacity
cells
≤ 3.0 Ah
2 x 3
The battery is supplied partially charged. The LEDs on
≤ 2.0 Ah
5
the battery indicate the charge condition.
≤ 4.0 Ah
2 x 5
When the battery is not used for longer periods, it
≤ 5.0 Ah
2 x 5
switches to the idle state.
Pay attention that the charger contacts are protected
against debris and moisture, and are not obstructed
through foreign objects. Do not operate the charger in
extreme hot or cold locations. It operates best at nor-
mal room temperature.
When fully discharged the rechargeable battery
switches off automatically (depth discharge not possi-
ble).
Under extreme circumstances, the internal temperature
of the battery could become to high. If this happens,
the battery will shut down.
Place the battery on the charger to charge and reset it.
The state of charge can be read by pressing the button
on the rechargeable battery. The battery can be left in
the electric tool while the reading is taken but it must be
switched off at least one minute beforehand (otherwise
the display will be inaccurate). The number of LEDs illu-
minated indicates the state of charge. A flashing LED
indicates a max. power reserve of 10 %.
As a general principle, if the electric tool should fail to
work after inserting the rechargeable battery, then the
battery should be plugged into the charger. The dis-
plays on the battery and charger will then provide
information about the condition of the battery.
In low temperatures work may continue at reduced out-
put.
The battery is automatically charged after inserting it to
the charger contacts (red LED lit).
This tool is only suitable for indoor use.
Never expose tool to rain.
Class II equipment
Time-lag fuse 5.0 A
T5.0 A
CE mark
Operating Instructions
12
Publicidad
