BGS technic 71039 Manual De Instrucciones página 4

USE
Measure the thread pitch with the thread gauge.
To do this, hold the thread gauge (12) against the thread of
the bolt (B).
If the teeth of the thread gauge do not fit into the thread, the
thread has a different pitch.
Try it with another sheet of thread gauge.
Hold the next sheet of thread gauge (12) against the bolt
thread (B).
If the teeth of the thread gauge fit into the bolt thread, the
pitch corresponds to that specified on the gauge sheet.
Choose the tap (7/8/9) with the correct pitch
and insert it into the holder (10/11).
Wheel hub (C)
Choose the die (1/2/3) with the correct pitch and clamp it in
the holder (4). Use the Allen key (6) to tighten.
Wheel hub (C)
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
10 / 11
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
7
8
9
4
1
2
3
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
C
C