Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY RULES
Remember, any equipment can cause injury if operated
improperly or if the user does not understand how to operate
the equipment. Exercise caution at all times when using this
equipment.
LOOK FOR THIS SYMBOL TO POINT OUT
IMPORTANT SAFETY PRECAUTIONS. IT
MEANS — ATTENTION! BECOME ALERT!
YOUR SAFETY IS INVOLVED.
NEVER allow anyone to operate the sweeper without proper
instructions.
NEVER permit children to operate sweeper.
NEVER push sweeper too close to a fire.
NEVER attempt to remove wire or string wrapped around
brush while brush is rotating.
ALWAYS wear eye protection while operating sweeper.
Operate sweeper at reduced speed on rough terrain, in
ditches and on hillsides to prevent tipping and loss of control.
Stay alert for holes or other hidden hazards.
This sweeper is not meant for street or highway use. Watch
for traffic when sweeping near roadways.
Keep all nuts and bolts tight.
Sweeper should be stopped and inspected for damage after
striking a foreign object and damage should be repaired
before operating the equipment.
Follow maintenance instructions as outlined in this manual.
OPERATION
Take care when operating your sweeper. Operating your
sweeper according to these instructions will help prevent
damage and prolong the life of your sweeper.
BRUSH HEIGHT ADJUSTMENT
To adjust your sweeper brushes to the best operating height,
loosen the hand knob and slide the height adjustment tube
down to raise or up to lower the brushes. Best adjustment is
when brushes are set 1/2" down into the grass. Always mow
grass to even height before sweeping. See figure 11.
11
CAUTION: EYE PROTECTION SHOULD BE
WORN WHILE OPERATING SWEEPER
STORAGE
The entire unit may be hung on a wall or the hopper bag frame
can be removed for storage.
DUMPING OF SWEEPER
To dump sweeper hopper bag, simply tip the sweeper forward or
lift off the complete hopper bag frame.
Always dump hopper after each use. Damp or wet grass and
leaves will cause damage to hopper if stored for long periods of
time.
CAUTION: DO NOT DUMP THE SWEEPER
TOO CLOSE TO A FIRE AS THE BRUSHES
AND BAG CAN BE DESTROYED BY
EXCESSIVE HEAT OR FLAME.
LUBRICATION/MAINTENANCE
The bearings in the sweeper have been prelubricated at the
factory. It is recommended that a few drops of light oil be added
to the brush shaft bearings twice a year. The wheels should be
removed to clean gears every two years. After cleaning, apply an
even coat of light grease. See figures 12, 13 and 14.
To remove the wheel, pop off hub cap with a screw driver
and remove retaining "E" ring and flat washer.
12
12, 25
28
5
NOTE:
18
24
Publicidad
