SoClean 2 Manual Del Usuario página 19

Figure 2. Connect the Injection fitting
Injection
Injection
hose A
fitting
Injection
hose B
2. Using an adapter
If your PAP machine requires an adapter, see adapter
instructions for set-up and proceed to Step 5.
3. Connect the Injection fitting
The Injection fitting connects the SoClean 2 to your PAP
machine. Once installed, you do not need to disconnect
the Injection fitting to use your PAP. The SoClean 2 is
intended to stay continuously connected to your PAP
machine.
Note: Your PAP reservoir model may require additional
configuration procedures or an adapter. If you have
difficulty with the steps in this guide, visit:
SoClean.com for information on various models.
With humidifier:
1. Position the Injection fitting onto the port of
your humidifier (where your PAP hose was
connected), allowing the smaller Injection hose B
to enter into the reservoir (Figure 2). The end of the
tubing should be positioned over the heat plate.
2. If necessary, carefully trim the Injection hose B in
increments until it is the correct length, and over
the heat plate.
For additional help in connecting to your specific
machine, please visit our support pages at:
SoClean.com
ENG | 15