Publicidad
Idiomas disponibles
Idiomas disponibles
Troubles
Close the breaker, but the
power light isn't on
No striking arc and no output
voltage
Welding stops, and alarm
light is on
Welding current is run away
and can be not controlled
The crater current can be not
adjusted
Reasons
Tip is jammed because of splash
Fuse damaged
Power damaged
Output cable is connected
mistakenly, or loosen
Control circuit damaged
Machine has self-protection
The potentiometer damaged
The control circuit damaged
The PCB damaged
No post-gas
18
SWEISSWELD.COM
Solution
Repair or change it
Change it
Change it
Screw it down or
change it
Check the circuit
Check over-voltage,
over-current,
over-temperature,
lower-voltage and
solve it
Check or change it
Check the circuit
Check it
Check it
Publicidad
