dB Technologies VIO X315 Manual De Uso página 28

CONNECTING AND LINKING THE RDNET SIGNAL
To enable remote control, connect the Data Input of the first speaker to the hardware interface (RDNet Control
2 or RDNet Control 8) using cables fitted with etherCON connectors. Then connect the Data Output of the first
speaker to the Data Input of the second, and so on. Power up the speakers and make a "GoOnline" request in the
AURORA NET software; the "Link" LEDs will confirm that they are connected.
The "Active" LEDs will start flashing to indicate that there is data traffic.
RDNET
CONTROL
3. REMOTE CONTROL
The AURORA NET software lets you manage several parameters of the VIO X315 speaker in real time.
In detail:
• Monitor the input and output signals
• View if there is audio compression on the output signal and acoustic components
• Attenuate the input signal
• MUTE the driver, midrange and woofer separately
• SOLO the driver, midrange and woofer separately
• Monitor the temperature of the amplifier
• Select the high pass filter cut-off frequency
• Save settings as presets for subsequent remote recall
• Equalise the speaker
• Add delay
VIO X315
28
Italiano
Cod. 420120425 REV. 1.0