Pur Line CHE-500 Manual De Usuario página 13

the appliance accidentally fall into water or have water or any other liquid spilt
over it isolate and unplug the appliance immediately and have it checked by
a qualified person before using it again. Non-observance could cause a fatal
electric shock!
• Do not use the appliance with wet hands, on a damp floor or when the
appliance itself is wet.
INSTALLATION
· This fireplace can only be mounted on the wall and NOT recessed mounting.
• We strongly recommend that a professional who has experience of fitting such
items should install Wall Fireplace.
• Wall Fireplaces are heavy objects and your safety is dependant on the
construction/strength of the wall to which it is attached.
• At least two people are recommended to install the Wall Fireplace.
• Wall fixings must be used for stability on this item and for safety reason the
Wall Fireplace should not be left freestanding.
• Do not connect the appliance until properly fixed to the wall and the instructions
is read fully.
• The screws and plugs supplied with this package are only suitable for SOLID
wall installation. For any walls other than solid, such as cavity, the appropriate
fixings MUST be used .
• Always ensure intended wall area to be drilled is free from hidden electrical
wires, water and gas pipes.
• Remove the appliance from the box and remove any packaging from the product.
• Place the packaging inside the box and either store or
dispose of safely.
• The fixing pack contains small items which should be kept
away from young children.
• We suggest that you open the fixing pack and place all
the contents into a container, therefore reducing the risk of
losing any small pieces.
• Inspect the air inlets and outlets to ensure that there are no
blockages.
Note: All wall mounted heaters may cause paint discoloration
overtime or wall paper to lift.
WALL MOUNTING
• Its recommended a minimun distance of 600mm from the
floor to the base of heater panel, and 900mm from adjacent
walls or furnishings.
1
• Decide on the position where the fireplace will be hang
on the wall. Measure and double-check distance between
the keyhole slots (1 A) on the rear part.
• Transfer the distance between the mounting holes on the
EN
1
2
13
WALL
A