Pur Line CHE-500 Manual De Usuario página 14

wall.
• Use a spirit level to ensure that the marks are levelled
vertically and horizontally.
• Drill the holes (Ø7mm) in the wall.
• Fix brackets to the wall with 4 screws provided with the unit.
• Lift the heater body and carefully lower it down to ensure
the heater body locks in with the brackets attached to the
wall.
2
• Two heater fixing wall brackets are supplied with the unit,
attach the bracket to the heater body with the wing nut
provided.
• Mark the fixing hole on the wall, remover the heater from the
wall and drill hole at the marked position. Insert the rawl plugs
/ correct screw anchoring plugs if on plaster board.
3
• Hang the heater back and secure it to the wall by screwing the bracket to the wall using the screws provided.
Ensure the heater body is engaged with the wall bracket.
4
• Unpack the pebbles and arrange them over the tray. You can adjust the position of the pebbles as you
require.
• Carefully hang the glass front to the hooks on the sides of the fire.
Note: Check the product periodically to ensure that no fittings has loosened and needs
attention.
WARNING: The appliance generates heat during operation. Proper precaution
must be taken to prevent the risks of burns, sculds, fire or other damage to any
person or property.
OPERATION
CAUTION: There may be some odour coming from the heater for the very first
time you use it. This is normal during the break-in period or after long term
storage. Make sure the heater is in well ventilated area and continue running it
until the odour goes away.
Insert the Kettle Lead Connector.
EN
3
Turn ON the Power Switch.
The main POWER switch, must
be switched ON in order for the
Remote Control or the Manual
Control Panel to function. If the
power switch was turned off, then
all function and settings would be
Cancelled and Initialized.
14
4