Pur Line CHE-500 Manual De Usuario página 15

CONTROL PANEL
A. ON/Off
Note: When power switch is turned on, the fireplace
was on standby status and indicator
Press ON/Off button once, the flame turn on at level
3 (high), and indicator
Press ON/Off button again, all function turn off and
the unit be on standby status.
Press and hold this button 3 seconds, all settings are
cancelled, and initialized.
B. Flame: Flame / Ambient
By pressing this button, the flame levels of
brightness can be adjusted. Press the button once
and the flame effect will be illuminated at level 1.
Press twice and the flame effect will be illuminated
at level 2 . Press three times and the flame effect will
be illuminated at level 3.
The indicator is on.
Press and hold this button 2 seconds, and the
ambient light would be turned on. Then user can
change the ambient light by pressing the button
circularly (7 colors optional, Red, Yellow, Green, Purple, Blue, Pink, White.)
Press and hold this button 2 seconds again, it would switch back to control the flame brightness.
C. Heat
This function might be effected by "Adaptive Start" or "Weekly Setting" function. Please make sure that "Adaptive
Start" or "Weekly Setting" function were turned off, or not on, before use the heating function separately. Those
two functions could be turned off by pressing ON/OFF button.
Press this button once, 1000W heater ON, and indicator "- - - " flashing.
Press twice, 2000W heater ON, and indicator "= = =" flashing.
Press this button three times, it would turn OFF heater.
This button would also be used as "Confirm"or "OK" on "Adaptive Start", " Time Calibration" and "Weekly Setting"
Mode.
D. Temp (Adaptive Start)
Note: Room temperature could be setted without turning on the heater.
Press this button to set room temperature at 18ºC/65F, 21C/70ºF, 24ºC/75ºF, 27ºC/80ºF, 30ºC/85ºF circularly.
Press TEMP or TIMING button to select the room temperature, and press
Press ON/OFF buttton to cancel or turn off Adaptive Start function.
Press and hold this button 2seconds to switch ºC/ºF.
Adaptive Start Function: if room temperature is detected lower than setted temperature, the heater would
auto-start to work.
While if room temperature is detected higher than setted temperature, the heater would be turned off
automatically.
Note: Settings under this mode might effect the function of "Weekly Setting".
* This button would also be used as "UP"selection on "Adaptive Start", " Time Calibration" and "Weekly Setting"
Mode.
E. Timing
* Press this button to set the working time from 1~24 hours circularly. Number is displayed on control board.
1. Press this button once and number "1" displayed, and indicator "O" on. And then
2. Press TEMP or TIMING button to select the working hours you want, and press HEAT to confirm.
3. Working time setting would be cancelled if "--:--" was selected.
Note: 1. Timing setting only be applicable when Flame and/or Heat function on
on.
is on.
EN
DATE
On
Off
Temp.
15
ºC
ºF
ON OFF
Flame Heat
Timing
Set up
button to confirm.