Publicidad
Idiomas disponibles
Idiomas disponibles
Lamp adjustment
The lampholder is aligned at the factory. Due to differences between lamps, fine adjustment may improve
light performance.
Strike the lamp, open the shutter and the iris, set the dimmer intensity onto 100 % and focus the light on a
flat surface (wall). Center the hot-spot (the brightest part of the beam) using the 3 adjustment screws "A, B,
1
CAUTION, HOT LAMP!
Let the lamp cool down for
10 min. Change the lamp by
loosening screws X and Y.
Adjust the lamp position by
turning screws A, B and C.
B
Focusing
Step 1: Loosen the focus button on the underside of the device.
Step 2: Adjust the focus by sliding the lenshousing forward or backward.
Step 3: Tighten the focus button.
Overhead rigging
Please consider the EN 60598-2-17 and the respective national norms during the
installation! The installation must only be carried out by an authorized dealer!
The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
A
2
C
Beam focus knob
DANGER TO LIFE!
16/35
C". Turn one screw at a time to drag the hot-spot
diagonally across the projected image. If you
cannot detect a hot-spot, adjust the lamp until the
light is even.
To reduce a hot-spot, pull the lamp in by turning
all three screws "A, B, C" clockwise ¼-turn at a
time until the light is evenly distributed.
If the light is brighter around the edge than it is in
the center, or if light output is low, the lamp is too
far back in the reflector. "Push" the lamp out by
turning the screws "A, B, C" counterclockwise ¼-
turn at a time the light is bright and evenly
distributed.
40002500_V_1_0_2643.DOC
Publicidad
