Publicidad
Idiomas disponibles
Idiomas disponibles
GB
When dealing with electricity, just conforming to all the safety and precautionary
measures can not describe every danger situation. They do not replace sensible pro-
cedures and care, which you have to take into account when first initiating and then
running your fan.
When using any electric units, several basic rules have to always followed, as detailed
below:
General
- The voltage details on the nameplate are to conform with the available mains voltage.
- The building mains must be earthed!
- Only operate the unit when completely assembled!
Operation
- The unit is to be operated on a level, stable base. Maximum altitude on firm surface: 80 cm
above the ground!
- Position the mains cable such that no danger of tripping is possible in order to avoid throw-
ing, or pulling the unit over.
- Do no push objects through the guard. Any loose objects which could be sucked in are to
be removed from the suction area before switching the fan on. Keep loose clothing, such as
scarves with fringes, away from the guard.
- The units are never be touched when having wet or moist hands.
- The units are never be used if you are barefooted.
- The units are never be used in a the bathroom or shower connected to an extension cord
unless you take exceptional care.
- Do not pull on the cable or unit in order to separate the plug from the socket.
- Do not subject the unit to detrimental environmental influences (rain, strong sunlight etc).
- This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction concerning use of the appliance in a
safe way and understands the hazards involved.
- Children shall not play with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
- Never immerse an electrical device in water.
- Always take note of the general safety rules when using electrical equipment.
Oscillation
Oscillation is switched on by pushing the knob (Pos. 8/9 fig. 10) downwards and off by pulling
it upwards.
Maintenance/cleaning notes
- Before carrying out any cleaning or maintenance work, remove the plug or switch off the
electrical equipment!
- The appliance shall be disconnected from its power source during service and when replacing
parts.
- The removal of the plug has to be such that an operator can check from any of the points to
which he has access that the plug rmeians removed.
10
Publicidad
