golmar 295 Serie Manual De Instalación página 36

DOOR PANEL INSTALLATION
Pass the wiring through the hole made in the bottom part
of the embedding box. Level and flush the embedding
box. Once the embedding box is placed, remove the
protective labels from the attaching door panel holes.
Insert the hinge in the embedding box lockers.
Press the hinge ends to insert them in the door panel
lockers as shown.
Open the terminal connector cover and connect
the wires as shown on the installation diagram.
In case of door panels with more than one module
link the main module with the push buttons modules
through the UC junctions and wire them as shown
on the following page.
68
P
lace the embedding box.
H
old the door panel on the embedding box.
D
oor panel wiring.
69
DOOR PANEL INSTALLATION
The maximum number of push buttons modules contained in a door panel
is two, obtaining a maximum of 24 push buttons.
Wire the push buttons modules with the main module as shown below.
Main module 1st push buttons module
PE4-295 or PV-295
CN2
L1 L2 CD1 CD2 CP L1 L2
Each push button has a digital code assigned in it, that will be recorded
on the corresponding monitor (telephone) during the recording progress.
In case to combine these door panels with "Stadio Plus" door panels or
with PV-295/CODE or PE4-295/CODE general entrance door panels,
it will be necessary to know these codes for a properly system configuration.
Main module 1st push buttons module
PE4-295 or PV-295
8
7
6
5
4
3
2
1
L
inking the push buttons modules.
2nd push buttons module
CD-295 CD-295
CN1 CN1
CP CD L1 L2 CP CD
P
ush buttons digital code.
2nd push buttons module
CD-295 CD-295
16 24
15 23
14 22
13 21
12 20
11 19
10 18
9 17