ARIETE 2705 Manual Del Usuario página 14

from openings and rotating parts of the appliance when it is running.
• Fill up the tank with water before starting up the appliance. Be sure to unplug the
appliance before pouring water into the tank.
• Turn on the appliance only when it is in working position.
• Never leave the appliance unattended when it is connected to the power supply.
• When you have to leave for even a short period of time, always place the appli-
ance on its accessory for carpet cleaning (P). Turn off the appliance and always
unplug the electric power cord.
• Store indoors in a cool, dry area.
• sAve these instructiOns fOr future refer-
ence.
DescriptiOn Of the AppliAnce
A - Steam dispensing button
B - Handle
C - Swivel cord storage hook
D - Handle release button
E - "ON" indicator light
F - Tank release lever
G - Motor body
H - Water tank
I - Filter
J - Fixed cord storage hook
K - Steam head
L - Turbo brush on button
M - Dust container
N - Brush cover
O - Washable cloth
P - Accessory for carpet cleaning
Q - Turbo brush
R - Washable cloth velcro couplings
S - Steam discharge nozzle
T - Power supply cable
AsseMbling the AppliAnce
Proceed as follows after removing the appliance from the box:
Assemble the motor body to the steam head (Fig. 2). Tighten the screw supplied to lock the components (Fig. 3).
Warning!
Check the tightening of the screw from time to time.
Press the handle release button (D). Lift the handle until it is aligned with the motor body (Fig. 4-5).
instructiOns fOr use
Totally unwind the power cord. To make the operation easier, turn the hook (C) downwards.
Remove the tank. Lift the tank release lever upwards as shown by the arrow (Fig. 6). At the same time tilt and remove the
tank. Turn the tank upside-down. Remove the cap (Fig. 7). Fill the tank up to the MAX level directly beneath the tap with cool
tap water (Fig. 8). Screw the cap back on, but not with excessive force.
Warning!
NEVER fill the tank beyond the MAX level. If the tap water is particularly hard (higher than 20°f), use a mixture of
50% tap water and 50% demineralised water.
Put the tank back in, paying attention to match the tank valve with the pin in the appliance seat (Fig. 9). Press the tank all
the way down until it is completely inserted and check that it is correctly installed.
14