Publicidad
Idiomas disponibles
Idiomas disponibles
INSERTING
BLANK SPACES
This section explains how to record from the tuner, CD player, or
external equipment.
—
,,___
_.-.
1
,11
1
Preparation
Use Type I (normal) tapes only.
Set the tape to the point where recording will start.
Note that recording is done on only one side of the tape.
1
2
3
Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
=
EJECT
Press function
(CD, TUNER or VIDEO/AUX)
and
prepare the source to be recorded.
To
record from a
CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER and tune
in to a station.
To record from a connected source, press VIDEO/AUX and
play.
Press
REC/REC
MUTE to start recording.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording,
press
,
To pause recording, press II. (Applicable when the source is
TUNER or VIDEO/AUX) To resume recording, press it again.
To start recording
with the remote
control
First press
/0
REC/REC MUTE, and then press<>
within 2
seconds.
Sound adjustment during recording
The output volume and tone of the speakers or headphones may
be freely varied without affecting the recording.
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER,
VIDEO/AUX or MD.)
1
Press
REC/REC MUTE during recording or while in
recording pause mode.
~
on the display flashes for 4 seconds and the tape runs
without
recording.
After 4 seconds, the deck enters the
recording pause mode.
2 Press 11 to resume recording.
To insert a blank space of less than 4 seconds, press
REC/REC MUTE again while ~
is flashing.
To insert blank !Waces of more than 4 seconds, after the deck
enters recording pause mode, press
REC/REC MUTE again.
Each time the button is pressed, a 4-second blank space is
added.
About cassette tapes
~To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
Tab for side A
To record on the tape again, cover the tab openings with
adhesive tape, etc.
o120-minute or longer tapes are extremely thin and easily
deformed or damaged, They are not recommended.
~Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
)
—
To erase a recording
Make sure the microphone is not connected to this unit.
Set the microphone volume to OFF (see page 19).
1 Insert the tape to be erased into deck 2 and press TAPE DECK
1/2 to display '(TP 2.
2 Set the tape to the point where the erasure is to be started.
3 Press
REC/REC MUTE to start the erasure.
13
ENGLISH
Publicidad
