Publicidad
Idiomas disponibles
Idiomas disponibles
REVERSING THE DOOR SWING
Door swing can be changed from a right-side opening to left-side
opening, if desired.
Place a towel or soft cloth on top of the dryer or work space
to avoid damaging the surface.
1.
Remove 3 of the 4 screws that hold the door hinge on the
front panel of the dryer. Partially loosen the remaining screw
with keyhole opening and lift the door off the screw.
A.
Dryer front panel
B.
Door assembly
2.
Lay the door assembly on a previously prepared flat surface
with the inside (inner door assembly) facing up.
3.
Remove the 6 Phillips head screws to release the outer door
assembly from the inner door assembly, as indicated below.
See illustration. It is important that you remove only the 6
indicated screws.
5.
Rotate outer door 180°.
1.
Use a small flat-blade screwdriver to remove 2 plug strips
from the inner door. Slide the head of the screwdriver under
the plugs, being certain not to scratch the inner door surface.
. &
at
Z
2.
Remove the 4 screws that attach to the inner door hinge and
move the hinge to the other side. Reinstall the 4 screws.
7
"¢
NSS
Sy
eo
Door hinge
3.
Reinstall plug strips on opposite side of the inner door.
4.
Check for fingerprints on the glass. Clean glass if necessary.
11
Publicidad
