Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Place the inner door assembly inside the outer door assembly.
2.
Remove the strike using a Phillips screwdriver.
To fit correctly, the inner door assembly edge fits completely
inside the outer door assembly edge.
3.
Insert strike on the opposite side.
6.
Reassembie the inner and outer door assemblies with the
6 screws.
1.
Reattach door to dryer front panel with the 4 screws.
Partially install the screw with keyhole opening first, and fit
the keyhole opening in the hinge over the screw. Then install
the remaining 3 screws and tighten all 4 screws.
Install this
NC
1.
Use asmail flat-blade screwdriver to remove plug strip from
the dryer door opening. Slide the head of the screwdriver
under the plugs, being certain not to scratch the dryer
surface. Lift the plastic strip from the dryer slowly to avoid
A. Dryer front panel
distortion of the plug strip.
B. Door assembly
2.
Check for fingerprints on the glass. Clean glass if necessary.
3.
Close door and check that it latches securely.
A. Plug strip
B. Door strike
12
Publicidad
