Cleaning the Charge Terminals
Charges may not be performed properly if there is dirt or foreign material on the charge
terminals. Be sure to pull the AC cable from the outlet. Then, wipe off dirt with a dry cloth
or cotton swab. Epson recommends cleaning the parts periodically (generally every 3
months).
K
!
CAUTION:
❏
After charging, the charge terminals can be very hot. Be careful not to touch them and
to let them cool before you clean them.
❏
Do not damage the charge terminals by touching them with your fingers or any hard
object.
❏
Do not expose the charge terminals to water. Perform the cleaning using a dry cloth or
cotton swab.
Troubleshooting
Charge LED does not turn on
❏
Check that the AC adapter is properly installed. (
)
page 5
❏
Check that the battery is properly installed. (
Charge LED is flashing
❏
Set the battery in the printer and turn the printer's power on. If the printer's Error
LED stays unlit, the temperature is outside the range that charging is possible in.
Charge the printer at an ambient temperature between 10 to 30°C {50 and 86°F}.
❏
If the printer's Error LED lights (when you turn the printer's power on), the battery is
faulty. Replace the battery with a new one.
Specifications
Item
Current consumption (at 24V)
Output
Charging duration*
Temperature/humidity
External dimensions (W × D × H)
Weight
*: For charging from 0 to 100% capacity when batteries are new and the environmental temperature is 25°C {77°F}.
The actual charging duration may be different, depending on the charging environment, battery status and so forth.
Specification
1.5 A
Charging voltage Max. 8.4V DC
Charging current
Max. 0.75A
Approx. 4 hours
During operation 0 to 40°C {32 to 104°F},
10 to 90% RH
During storage
High temperature and humidity: 50°C {122°F}, 90% RH
for 120 hours
High temperature: 70°C {158°F} for 120 hours
Low temperature: -25°C {-13°F} for 120 hours
94.0 × 70.9 × 76.1 mm {3.70 × 2.79 × 2.99"}
Approx. 180 g {0.4 lb}
U "Connecting the AC adapter" on
U "Charging the Battery" on page 6
)
7