Publicidad
Idiomas disponibles
Idiomas disponibles
Replacement
and Care of Filter
WARNING:
To reduce the risk of shock or
injury from moving parts, always unplug
humidifier before removing or replacing any
parts.
Grasp housing
assembly
securely
and
lift off
CAUTION:
To help retard bacteria growth
and keep maximum efficiency, the filter
should be replaced at least once per season,
or more often under hard water conditions.
Use Kenmore 32-14906 recommended
replacement filter.
Replace the evaporative wicking filter at least once
per humidification season or more depending on
water conditions in your area.
Filter
Replacement
1. Unplug humidifier. Before removing the filter,
we recommend moving the humidifier to an
area where floor coverings are not susceptible
to water damage. (i.e. kitchen or bath areas.)
2. Remove the water bottle and set aside. Be sure
not to bump or damage the fill valve.
3. Grasp the housing assembly and lift straight up
and away from the base and set aside. The
filter is now accessible.
,
Take note of the filter position. Remove the
filter. You may want to clean the base at this
time. See the "Cleaning Your Humidifier"
section of this manual.
5. Install a new filter (32-14906) into the base.
Coil the filter and position it between the
uprights in the bottom of the base. The start
and finish of the coil should be captured at the
center of the base (see diagram) and the filter
should be resting on the floor of the base.
6. Return the housing assembly to the top of the
base. Reposition the humidifier to its operating
position.
7. The humidifier is now ready to be filled for
operation.
Position
start
and finish
of
oiled
filter
at
enter
of base
Align
housing
-_
assembly
---_-__
bottom
with
top of base
and reposition
securely
11
Publicidad
