Publicidad
Idiomas disponibles
Idiomas disponibles
Step 3. Water Fill
WARNING:
To reduce the risk of fire or
shock hazard, do not pour or spill water into
control or motor area.
If controls get wet, let them dry completely
and have unit checked by authorized service
personnel before plugging in.
Bottle
After the humidifier is positioned where it will be
operating you are ready to fill the humidifier. The
bottle lifts straight up and away from the base.
Take care not to bump or damage fill valve
assembly on the bottom of the bottle.
Remove the "E-Z Fill Side Cap" and fill with water.
Replace cap and twist by hand until secure. Hold
the bottle upright
valve plunger for
amount of water.
over the sink. Press up on the
one second to release a small
If you hear air bubbles or see
leaks around the "E-Z Fill Side Cap" or Spring
Valve Assembly, retighten and recheck.
Base
Turn
Counterclockwise
to
Remove
"E-Z Fill Side
Cap"
/
CAUTION:
Use only 32-14900 EPA
Registered Bacteriostat available from Sears
Retail store. Under no circumstances should
you use water treatment products designed
for Roto belt or Ultrasonic humidifiers.
Place the water bottle back into the humidifier
base. When positioned properly, the plunger wilt
open and the water will flow into the base. The
base will hold the entire contents of the water
bottle. Once the bottle is empty, remove it and
repeat the filling process. The humidifier is now
filled to capacity. To benefit from less frequent
filling let the humidifier exhaust both the water
from the bottle and the base before filling.
/
,/
Spring
Valve
Assembly
6
Publicidad
