Publicidad
Idiomas disponibles
Idiomas disponibles
Setting functions and options
You can change options for a number of system functions. Available functions depend on
the type of system you have. The functions, designated with four-digit numbers, along with
available options are described on pages 32–36.
This thermostat is pre-set for a single-stage heating/cooling system.
Setting function 0170 for a heat pump will adjust the default settings.
1 Press SYSTEM. You'll see several blank buttons
on the bottom of the display.
2 Press and hold the center blank key for
approximately five seconds until screen
changes.
3 Cycle through the functions, press
the four digit number on the left.
4 As needed, change options for any function by
pressing
st
5 When you have made all changes, press
to save and exit.
69-2715EF—01
next to the number on the right.
next to
st
DONE
31
SYSTEM
HEAT
6:30
PM
DONE
20
0120
DONE
CANCEL
Publicidad
