Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
9
iNSTALL BELT ON ENGINE CLUTCH PULLEY (M)
(See Fig. 7 & 15)
•
Disengage belt tension rod (K) from locking bracket (L).
•
Install belt onto engine clutch pulley (M).
M.ENGINE
CLUTCH PULLEY
Fig. 15
iMPORTANT:
Check belt for proper routing in all mower
pulley grooves and under mandrel covers.
•
Engage belt tension rod (K) on locking bracket (L).
i
CAUTION: Belt tension
rod is spring loaded. 1
_ill
Have a tight grip on rod and engage slowly.
•
Raise attachment lift lever to highest position.
•
If necessary,
adjust gauge wheels
before
operat-
ing mower as shown in the Operation section of this
manual.
MOWER
DRIVE BELT INSTALLATION
Follow procedure described in "TO REPLACE MOWER
BLADE DRIVE BELT " in the "Service and Adjustments"
section of this manual.
CHECK
TIRE PRESSURE
The tires on your tractor were overinflated at the factory
for shipping purposes.
Correct tire pressure is important
for best cutting performance.
•
Reduce tire pressure to PSI shown on tires.
CHECK
DECK LEVELNESS
For best cutting results, mower housing should be properly
leveled. See "TO LEVEL MOWER HOUSING" in the Service
and Adjustments section of this manual.
CHECK
FOR
PROPER
POSITION
OF ALL
BELTS
See the figures that are shown for replacing motion and
mower blade drive belts in the Service and Adjustments
section of this manual.
Verify that the belts are routed
correctly.
CHECK
BRAKE
SYSTEM
After you learn how to operate your tractor, check to see that
the brake is operating properly. See "TO CHECK BRAKE"
in the Service and Adjustments section of this manual.
'CHECKLIST
BEFORE YOU OPERATE YOUR NEW TRACTOR, WE
WtSH TO ENSURE
THAT YOU RECEIVE
THE BEST
PERFORMANCE
AND
SATISFACTION
FROM
THIS
QUALITY PRODUCT.
PLEASE REVIEW THE FOLLOWING CHECKLIS_
J"
All assembly instructions have been completed.
J"
No remaining loose parts in carton.
J"
Battery is properly prepared and charged.
J"
Seat is adjusted comfortably and tightened securely.
J"
All tires are properly inflated. (For shipping purposes,
the tires were overinflated at the factory.)
J"
Ensure mower deck is properly leveled side-to-side/
front-to-rear for best cutting results.
(Tires must be
properly inflated for leveling.)
J"
Check mower and drive belts. Ensure they are routed
properly around pulleys and inside all belt keepers.
J"
Check wiring. See that all connections are still secure
and wires are properly clamped.
J"
Before driving tractor, ensure freewheel control is in
"TRANSMISSION
ENGAGED"
position.
(See "TO
TRANSPORT" in the Operation section of this manual.)
WHILE LEARNINGHOWTO USEYOUR TRACTOR, PAYEXTRA
ATTENTION TO THE FOLLOWING IMPORTANT ITEMS:
J"
Engine oil is at proper level.
J"
Fuel tank is filled with fresh, clean, regular unleaded
gasoline.
J"
Become familiar with all controls, their location and
functions.
Operate them before you start the engine.
J"
Ensure brake system is in safe operating condition.
J"
Ensure
Operator
Presence
System
and Reverse
Operation System (ROS) are working properly. (See
the Operation and Maintenance sections in this manual.)
9
Publicidad
