Descargar Imprimir esta página

Televes COFDM-QAM 5556 Manual De Instrucciones página 45

Publicidad

Idiomas disponibles

Idiomas disponibles

User manual
The list of input services is only
shown but it is not possible to elimi-
nate any services.
Proc.
Processing mode: the user may
modify the QAM output baud rate
between the minimum value to
accommodate the input signal, and
6.9 Mbaud. It is also possible to
select which input services will be
eliminated at the output.
The firmware version of the transport stream
processing module is also shown (FPGA).
d.- Language selection menu
The last extended menu allows the selection
of the menus language (English/Spanish).
By pressing
or
you switch between
different languages.
5.3.- PARAMETERS SAVING
Once a parameter is modified to the desired
value in any menu (normal or extended), to
save the settings press
seconds. The display will show the following
indication:
If the configuration paremeters are modified
but not saved the previous configuration is
retrieved after 30 sec. in other words the
changes are discarded.
Finally, the LEDs indicate the following opera-
ting conditions:
A
B
C
Correct operation
A
B
C
Insufficient input signal level
(for purposes of illustration)
45
COFDM QAM - TS PROC
A
Detachment of the COFDM demodulator
for three
A
Detachment of the QAM modulator
The LEDs that are illuminated indicate correct
operation. If any of them go out, this is an
indication of faulty behaviour.
B
C
B
C

Publicidad

loading