Generac 1536-0 Manual Del Propietário página 13

Generac Portable Products 2,100 PSIHigh Pressure Washer
Check In-Line Filter
Refer to Figure20 and service the in-linefilter if it
becomes clogged, as follows:
I.
2.
.
Filter Screen
Nozzle Extension
O-rin
Detach spray gun and nozzle extension from high
pressure hose. Detach nozzle extension from spray
gun and remove o-ring and screen from nozzle
extension. Flush the screen, spray gun, and adjustable
nozzle extension with clean water to clear debris.
if the screen is damaged, the o-ring kit contains a
replacement in-llne filter screen and an o-ring. If
undamaged, reuse screen.
Placethe in-line filter screen into the threaded end of
the nozzle extension. Direction does not matter. Push
the screen in with the eraser end of a pencil until it
rests fiat at the bottom of the opening. Take care to
not bend the screen.
4. Placethe o-ring into the recess. Pushthe o-ring snugly
against the in-linefilter screen.
5. Assemble the nozzle extension to the spray gun, as
described earlier in this manual.
Purge Pump of Air and
Contaminants
To remove air from the pump, follow these steps:
• Set up the pressure washer as described in "Preparing
Pressure Washer For Use". Connect the water supply
and turn water on.
•Putl the trigger on the spray gun and hold.
• When the water supply is steady and constant, engage
the safety latch.
To remove contaminants from the pump, follow
these steps:
• Set up the pressure washer as described in "Preparing
Pressure Washer For Use". Connect the water supply
and turn water on.
• Start the engine according to instructionsin "To Start
Your Pressure Washer".
• Remove nozzle extension from spray gun.
• Squeezethe trigger on the spray gun and hold.
• When the water supply is steady and constant, engage
the safety latch and attach the nozzle extension.
Nozzle Maintenance
if the adjustable nozzle becomes restricted or clogged with
foreign materials, such as dirt, excessive pump pressure
may develop. A pulsing sensation occurs during use. This
generally is not a pump related problem, but rather a
clogged or partially restricted nozzle.
If the adjustable nozzle becomes clogged or partially
restricted, immediately clean the nozzle with the kit
included with your pressure washer by following these
instructions:
• Shut off the engineand turn off the water supply.
• Separatethe nozzle extensionfrom the spraygun.
• Adjust the nozzle extension to the stream position.
• Remove the nozzle from the end of the nozzle extension
(Figure 21) using a 2mm or 5/64 allen wrench (like the
one included in the kit).
i
13