Descargar Imprimir esta página

Domo DO1103SV Manual De Instrucciones página 40

Aspirador escoba

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 44
AFFIXING THE WALL MOUNT
·
Hold the wall mount against the wall and use a pencil the mark the drill holes. Please
ensure the distance between the power socket and the upper drill holes is no more
than 1.5 metres. The minimum height for wall mounting is 1.2 metres.
·
Drill the holes. We recommend using screws with a diameter of 4 mm and a length of
30 mm.
·
Push two plugs (suitable for screws measuring 4 mm in diameter and 30 mm in length)
into the drilled holes. Hold the wall mount flush with the drill holes and screw to affix.
·
You can now hang the appliance in the wall mount and connect the adapter as
described above.
USE
·
Assemble the unit as described earlier in this manual.
·
For large areas, use the floor brush together with the wand.
·
For smaller areas (e.g. car) or higher surfaces (e.g. tables, chairs, etc.), use the appliance with just the
floor nozzle.
·
For hard-to-reach places (e.g. corners, narrow openings, etc.), click the crevice tool into the suction
opening.
·
Use the dusting brush when using the appliance on sofas, curtains or other types of textiles.
·
Press the on/off switch once to turn the appliance on. The appliance will start working. The appliance
has 3 settings:
· LOW: white light off
· MED: white light on
· HIGH: Blue light on
Adjust the suction by pressing the mode button repeatedly. Lower suction means longer usage time.
·
Suction power will decrease when the battery is almost empty. The upper battery light will switch off
first, then the bottom light will flash and the appliance will stop working eventually.
·
This appliance must only be used on a dry surface. When you switch on the machine, the rotating floor
brush at the bottom of the floor nozzle will begin to turn. This will cause the dirt in the opening to be
shifted and thereby vacuumed up. Dirt will collect in the container.
Be careful not to suck up large pieces of dirt, as this could block the suction opening and damage the
appliance.
·
For the best results, clean the dust reservoir and the filters after each use. This is better for the suction
power and the life span of the machine.
CLEANING AND MAINTENANCE
THE FLOOR BRUSH
·
Remove the floor brush after every use and remove any hairs or dirt from the rotating brush.
·
Click the release flap at the bottom of the floor brush and remove the rotating brush.
·
You can now remove and clean the rotating brush.
·
After cleaning, place the rotating brush back into the floor brush and click the locking mechanism back
into place.
40
DO1103SV

Publicidad

loading