Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
35
ERROR CODES
_!_i_i_iiii_!_!_!!i!!!!iiiiiiii_i_!_i_!_!_i_i!ii_!_iiiiiii_i_!_!!ii!!_i_!_!_!!_!!_!!_!!_!_!_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_
iThe display shows:
i||
shows:
i
The display shows:
Washer fills with water slowly or
not at all, or the display shows:
Washer will not turn on
The lid is not closed properly.
Lid lock switch error.
Special Drain Feature.
Water supply faucets are not fully
open.
Water line hoses are kinked,
pinched, or crushed.
Water inlet filters are clogged.
Water supply pressure to faucet or
house is too low.
Water supply connected with leak-
limiting hoses.
Power cord is not properly
plugged in.
House fuse is blown, circuit break-
er has tripped, or power outage
has occurred.
Make sure that the lid is closed properly
and press the START/PAUSE button. After
starting
a cycle, it may take a few moments
before the tub begins to turn or spin. The
washer will not spin unless the lid is locked.
If the lid is closed and the lid lock error mes-
sage is displayed, call for service.
Make sure that the lid is closed properly and
sress the START/PAUSE button. The washer
will not operate unless the lid is locked.
Make sure that nothing is caught under the
lid, including shipping material or clothing.
Make sure that the latch mechanism
is fully
retracted.
If the lid is closed and the lid lock error mes-
sage is displayed, call for service.
If the washer is paused during a cycle for
more than five minutes, the cycle will be
cancelled and any water remaining in the tub
wiUI be drained.
Make sure that the water faucets are fully
open.
Make sure that the hoses are not kinked or
3inched. Be careful when moving the washer
during cleaning and maintenance.
Clean the inlet filters. See Maintenance
in
the Care and Cleaning section.
Check another faucet in the house to make
sure that household
water pressure is ad-
equate and flow is not restricted.
Disconnect
the inlet hose from the washer and run a few
gallons of water through the hose to flush
the water supply lines. If flow is too low,
contact a plumber to have the water lines
repaired.
Hoses designed to limit leaks can trip falsely
and prevent the washer from filling. The use
of leak limiting hoses is not recommended.
Make sure that the plug is plugged seruely
into a grounderd, 3-prong. 120-VAC, 60-Hz.
outlet.
Reset circuit breaker or replace fuse. Do not
increase fuse capacity. If the problem is a
circuit overload, have it corrected by a quali-
fied electrician.
Publicidad
