Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved
around the hole.
Be sure the thickness of the work surface is at least 30 mm. Please select heat-
resistant work surface material to avoid larger deformation caused by the heat radiation
from the hotplate. As shown below:
L(mm)
W(mm)
590
520
Under any circumstances, make sure the ceramic cooker hob is well ventilated and the
air inlet and outlet are not blocked. Ensure the ceramic cooker hob is in good work
state. As shown below
Note: The safety distance between the hotplate and the cupboard above the
hotplate should be at least 650 mm.
H(mm)
D(mm)
52
48
A(mm)
B(mm)
650
50 mini
EN-15
A(mm)
B(mm)
560
490
C(mm)
D
20 mini
Air intake
X(mm)
50 mini
E
Air exit 5mm
Publicidad
