Publicidad
Idiomas disponibles
Idiomas disponibles
Before installing the hob
• The work surface is square and level, and no structural members interfere with space
requirements.
• The work surface is made of a heat-resistant material.
• If the hob is installed above an oven, the oven has a built-in cooling fan.
• The installation will comply with all clearance requirements and applicable standards
and regulations.
• A suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and positioned to comply with the
local wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air gap
contact separation in all poles (or in all active [phase] conductors if the local wiring
rules allow for this variation of the requirements).
• The isolating switch will be easily accessible to the customer with the hob installed.
• You consult local building authorities and by-laws if in doubt regarding installation.
• You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
surfaces surrounding the hob.
After the hob is installed
• The power supply cable is not accessible through cupboard doors or drawers.
• There is adequate flow of fresh air from outside the cabinetry to the base of the hob.
• If the hob is installed above a drawer or cupboard space, a thermal protection barrier
is installed below the base of the hob.
• The isolating switch is easily accessible by the customer.
Installation
Cut out worktop to supplied dimensions shown (fig. 1) with suitable equipment. Seal
the cut edge of the worktop using Silicone or PTFE and allow to dry prior to fitting the
hob.
EN-16
Publicidad
