Holiday Travel 916882 Manual Del Usuario página 16

CONNECT THE GAS CARTRIDGE (FIGURE 1 , PAGE 13)
DE
• Check the sealing condition before using a new gas cartridge or connecting the gas cartridge to
the equipment.
EN
• (Refer to: Removing gas cartridge when existing cylinder is empty).
• When installing or removing gas cartridges, be sure to work in a well ventilated area, preferably
IT
outdoors. Do not work with flames, heat sources, or sparks (lit cigarettes, electrical equipment,
etc.), and keep a certain distance from other people and flammable objects.
Due to the fact that the suitable gas cartridge is operated by a valve, it can be removed from the
ES
equipment for convenient transportation (even if it is not empty), and installed and adapted for use
on this gas grill.
FR
(1) As shown in Figure 1-A, turn the control knob k clockwise until it stops (the arrow points to
"–"), to close the gas connection.
NL
(2) Check the condition of the sealing ring e. If the gasket is damaged, worn, or missing, do not
use the device, and contact a after-sales representative to replace the gasket.
(3) As shown in Figure 1-B, tighten the gas cartridge (counter clockwise) and the fuel gas connec-
FI
tor.
(4) Place the gas grill and gas cartridge on the same solid surface, and pay attention to keeping
the flexible gas pipe away from the gas grill (flame).
DK
The device is now ready to use.
If there is a leak (smell of gas before opening the valve), please immediately take the equipment
SE
outdoors and place it in a well ventilated place without combustion heat sources. Find the leak
point and stop the leak. If you want to check whether the equipment is properly sealed, please do
so outdoors. Do not attempt to locate the leak point with flame. Please use a gas leakage solution.
USE OF GAS GRILLS
1� Piezoelectric ignition (Figure 2, Page 13)
As shown in Figure 2-A, turn the control knob k counterclockwise for about 1/3 turn (the arrow
points to "+" turn it down properly when the cylinder is full) to turn on the gas.
As shown in Figure 2-B, repeatedly press the button i until the gas grill is ignited.
Note: If the piezoelectric ignition fails, turn the control knob clockwise until it stops (the arrow
points to "-") and turn off the gas. Wait one minute before attempting a second attempt, or follow
the ignition procedure below.
Ignition by ignition gun:
Place the ignition gun head close to the burner (Figure 2-C), rotate the control knob counterclock-
wise (the arrow points to "+"), gradually turn on the gas, and press the ignition gun switch
(Figure 2-C).
2� Cooking
After preheating, place the barbecue ingredients on the grill and place them in the center of the
burner. Adjust the gas flow rate so that the flame does not spill out of the fire shield. Due to the
open combustion of the product, there may be variations in the fire power at the end away from
the gas inlet. When using, wear barbecue gloves to protect you from the effects of temperature.
3� Turn off flame
When you have finished cooking, turn the control knob k clockwise until it stops (the arrow points
to "-"), and turn off the gas.
HOLIDAY TRAVEL Portable gas grill | 916882
16