Create IRON UP STAND Manual Del Usuario página 13

Please check the following points before entrusting the maintenance department to make
repairs
PROBLEM
The power cord plug is not plugged
Not working at all,
the switch light is
not on
No steam but the
Thermal fuse damaged Thermostat
switch light is on
Steam is too small
Nozzle air hole downward or nozzle
Nozzle is leaking
The hole nut is not tightened or the
Watertank leaking
The whole machine The tilt Angle is too large when the
Is leaking
Drain knob or drain knob or internal
Deformación
The tilt Angle is too large when the
del depósito
It is a normal phenomenon that a big amount of air flow generated by steam impinges on the nozzle,
and the sound of "puff" is occasionally heard at the nozzle. You can use the steam iron as usual.
The water in the boiler will produce the sound of "purr" due to boiling, which is a normal phenomenon.
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous
substances in electric and electronic equipment as well as their waste disposal. The symbol with the
crossed dustbin shown on the package indicates that the product at the end of its service life shall be
collected as separate waste. Therefore, any products that have reached the end of their useful life must
be given to waste disposal centres specialising in separate collection of waste electrical and electronic
equipment, or given back to the retailer at the time of purchasing new similar equipment, on a one for one
basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled,
treated and disposed of in an environmentally compatible way contributes to preventing possible nega-
tive effects on the environment and health and optimises the recycling and reuse of components making
up the apparatus. Abusive disposal of the product by the user involves application of the administrative
sanctions according to the laws.
COMMON PROBLEMS
POSSIBLE CAUSES
into
the power supply
The upper power switch is dama-
ged Thermal fuse damaged
There is no water in the tank
damage
The voltage is too low Scale clogs
up steam pipes
below the water level of the tank
Nozzle broken
water tank is broken
Steam hose is not well vented or
blocked
Drain valve knob or sewage outlet
knob is not tightened
machine is working or moving
pipe damage
machine is working or moving
SOLUTION
Plug the power cord into a live socket Please
ask a professional to check it
Fill the tank with the right amount of water
Please ask a professional to check and
maintain
Please ask a professional to check and
maintain
Please avoid using this product during peak
hours
Please refer to "scale removal method" in
the instruction manual for scale removal
Please lift nozzle to water level of water
tank above or the nozzle along the vertical
direction of operation please professional
inspection and maintenance
Tighten the water injection hole nut or ask a
professional for maintenance
Avoid steam hose folding or professional
maintenance
Please tighten the drain valve knob or
sewage outlet knob.
Avoid excessive inclination Angle when the
machine is working or moving Please ask a
professional to check and maintain
Please replace the water tank (standard
water tank)
E NGLI SH
13