Publicidad
DISASSEMBLY AND REASSEMBLY INSTRUCTIONS
D i s c o n n e c t t h e m a c h i n e f r o m t h e
c o m p r e s s e d a i r s u p p l y . R e m o v e a l l
accessories.
At each disassembly of the bevel gear, change the
Nylstop nut (605.57).
Before removing the turbine assembly from
the motor housing, do not forget to remove
the decompression fitting (746.52).
At each disassembly of the governor, clean the
spring housing, check the condition of the spring
and re-lubricate it carefully.
The governor has a calibrated spring which
can only be replaced by an original spare
part.
When re-assembling, always position the cylinder
exhaust on the opposite side of the turbine
housing.
Overspeed air shut-off device
Be particularly careful with the speed governor and
the overspeed air shut-off device. Careless
maintenance or treatment may prevent them from
functioning correctly. If the machine stops suddenly
or does not reach rated speed when connected to
the air supply, the overspeed shut-off device may
have closed the inlet air.
The machine must imperatively be dismantled and
checked before resetting the overspeed shut-off
device (see drawings below).
1
KA160B7Y - KA177B7Y
KA160B9Y
Part no
6159947040
Issue no
03
Series no
B
Date
09/2008
Page
11 / 48
OK
2
1
2
3
30 N.m
OK
4
Publicidad
