Publicidad
Idiomas disponibles
Idiomas disponibles
TO REMOVE
CABLES,
REVERSE
ORDER
-
1.
BLACK
cable
first from chassis
and
then from
the fully charged
battery.
2.
RED cable
last from both batteries.
Weak or Dead
Fully Charged
Battery
Battery
REPLACING
BATTERY
_I_WARNING:
Do not short battery
terminals by allowing a wrench or any
other object to contact both terminals at
the same time. Before connecting
battery,
remove metal bracelets, wristwatch
bands,
rings, etc.
Positive terminal must be connected
first to prevent sparking from accidental
grounding.
1. Lift seat pan to raised position.
2. Disconnect
BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
3. Install new battery with terminals in
same position as old battery.
4. First connect RED battery cable to
positive (+) terminal with hex bolt and
keps nut as shown. Tighten securely.
Slide terminal cover over terminal
5. Connect BLACK grounding
cable to
negative (-) terminal with remaining
hex bolt and keps nut. Tighten securely.
TO REPLACE
HEADLIGHT
BULB
1.
Raise
hood.
2.
Pull bulb holder
out of the hole in the
backside
of the grill.
3.
Replace
bulb in holder
and push bulb
holder
securely
back into the hole in
the backside
of the grill.
4.
Close
hood.
INTERLOCKS
AND
RELAYS
Loose
or damaged
wiring
may cause
your tractor
to run poorly,
stop running,
or
prevent
it from starting.
,
Check
wiring.
See electrical
wiring
diagram
in the Repair
Parts section.
TO REPLACE
FUSE
Replace
with 20 amp automotive-type
plug-in
fuse.
The fuse holder
is located
behind
the dash.
TO REMOVE
HOOD
AND
GRILL
AS=
SEMBLY
1.
Raise
hood.
2.
Unsnap
headlight
wire connector.
3.
Stand
in front of tractor.
Grasp
hood at
sides,
tilt toward
engine
and lift off of
tractor.
4.
When
replacing
hood,
be sure to re-
connect
the headlight
wire connector.
Hood
Headlight Wire
Connector
Seat
Label
Terminal
Cover
Keps
Nut
aex
Bolt
Positive
(Red)
Cable
Negative (Black)
Cable
26
Publicidad
