Descargar Imprimir esta página

Craftsman 917.28705 Manual Del Operador página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Lower seat into operating position and
sit in seat.
7. Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
8. Get off seat without moving its ad-
justed position.
9. Raise seat and tighten adjustment
knobsecurely.
Seat
Bolt
Flat Washer
\
Adjustment
Knob
CHECK
BATTERY
1.
Lift seat pan to raised
position.
NOTE:
If this battery
is put into service
after month
and year indicated
on label
(label
located
between
terminals)
charge
battery
for minimum
of one hour at 6-10
amps.
(See "BATTERY"
in Maintenance
section
of this manual
for charging
instruc-
tions).
Seat
Label
Terminal
Terminal
NOTE: You may now roll or drive your
tractor off the skid. Follow the appropriate
instruction
below to remove the tractor
from the skid.
WARNING:
Before starting, read, un-
derstand and follow all instructions
in the
Operation section of this manual. Be sure
tractor is in a well-ventilated
area. Be sure
the area in front of tractor is clear of other
people and objects.
TO ROLL
TRACTOR
OFF SKID
(See
Operation
section
for location
and
function
of controls)
1. Press lift lever plunger and raise
attachment
lift lever to its highest po-
sition.
2. Release parking brake by depressing
clutch/brake
pedal.
3. Place gearshift lever in neutral (N)
position.
4. Roll tractor forward off skid.
5. Remove banding holding the deflector
shield up against tractor.
TO DRIVE
TRACTOR
OFF SKiD
(See Operation
section
for location
and function
of controls)
1. Be sure all the above assembly steps
have been completed.
2. Check engine oil level and fill fuel tank
with gasoline.
3. Sit on seat in operating position,
depress clutch/brake
pedal and set the
parking brake.
4. Place gear shift lever in neutral (N)
position.
5. Press lift lever plunger and raise
attachment
lift lever to its highest posi-
tion.
6. Remove key from bag and start the
engine (see "TO START ENGINE" in
the Operation section of this manual).
After engine has started, move throttle
control to idle (slow) position.
7. Depress clutch/brake
pedal into full
"BRAKE" position and hold. Move
gearshift lever to 1st gear.
8. Slowly release clutch/brake
pedal and
slowly drive tractor off skid.
9. Apply brake to stop tractor, set park-
ing brake and place gearshift lever in
neutral position.
10.Turn ignition key to "STOP" position.
Continue with the instructions
that follow.
9

Publicidad

loading