Descargar Imprimir esta página

Panasonic TY-ST58PF10 Instrucciones De Instalación página 8

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 47
3. Install the plasma display to the mobile stand
For 58-inch plasma display
Befor install the plasma display pasting the 4
gaskets inside the stamp marks of the holders.
● Do not pasting seals except 58 inch plasma display.
1. Fitting of the plasma display main body to
the stand
Hook the insulating spacer on the upper
side of the plasma display main unit to the
upper notch on the stand. Pull down the
plasma display main body.
While lifting the plasma display main body
slightly, insert the insulating spacer on
the lower side of the plasma display main
body into the holes on the stand. Pull
down the plasma display main body
Note
If the plasma display main body is lifted excessively,
then the upper spacers may be unhooked.
Caution
Before fitting the plasma display, make sure to lock the
casters.
Locking and unlocking the casters
Caster locked
Push the
bottom of
the lever.
2. Fixing of the plasma display main body
Tightly fasten the fixing screws (M5x35) into
the two screw fitting holes for fixing of the
holders (on the left and right).
Caution
● Make sure to fit the fixing screws on the left and right
to prevent the plasma display main body from coming
off.
● Fasten the fixing screws with a torque of 1.5 to 2
N·m.
Caster unlocked
Push the top
of the lever.
Stamped marks
Upper notch
Screw fitting holes for fixing
Fixing screws
(M5x35)
Gasket
Holder
Lower notch
17

Publicidad

loading