LG WM3170CW Manual De Propietario página 15

INSTALLATION INSTRUCTIONS 15
Connecting fhe drain line
Secure the drain hose in place to prevent it from
moving and leaking.
_@ NOTE
The drain hose should be properly secured.
Failure to properly secure the drain hose can
result in flooding and malfunction.
The end of the drain hose should not be lower
than 29 inches (73.66 cm) or higher than 96
inches (244.8 cm) from the bottom of the
washer.
The drain must be installed in accordance with
any applicable local codes and regulations.
Make sure that the water lines are not
stretched, pinched, crushed, or kinked.
.... /
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10
cm) from the end of the drain hose. If the drain
hose is extended more than 4 inches (10 cm)
beyond the end of the elbow bracket, mold or
microorganisms could spread to the inside of
the washer.
_ No more than
4 inches (10 cm)
bracket
Insert the end of the drain hose into the
standpipe.
Elbow Bracket
3 Use a tie strap to secure the drain hose in place.
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10
cm) of the end of the drain hose. If the drain
hose is extended more than 4 inches (10 cm)
beyond the end of the elbow bracket, mold or
microorganisms could spread to the inside of
the washer.
_oi No more than
4 inches (10 cm)
bracket
2 Hang the end of the drain hose over the side of
the laundry tub.
_i_ E Ib_ow Bracket
Drain Hose
3 Use a tie strap to secure the drain hose in place.