Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
To prevent serious injury, never perform
maintenance or repairs while the unit is running. Always
allow the unit to cool before servicing or repairing the unit.
Disconnect the spark plug wire to prevent the unit from
starting accidentally.
MAINTENANCE
SCHEDULE
Perform these required maintenance procedures at the frequency
stated in the table. These procedures should also be a part of any
seasonal tune-up.
All service, other than the maintenance
procedures described in
this manual, should be performed by a Sears or other qualified
service dealer.
NOTE: Some maintenance procedures may require special tools or
skills. If you are unsure about these procedures, take the unit to
a Sears or other qualified service dealer. Call 1-888-331-4569
for more information.
NOTE: Maintenance,
replacement,
or repair of the emission control
devices and system may be performed by a Sears or other qualified
service dealer. Call 1-888-331-4569
for more information.
NOTE: Please read the California/EPA statement that came with the
unit for a complete listing of terms and coverage for the emissions
control devices, such as the spark arrestor, muffler, carburetor, etc.
CUSTOMER
RESPONSIBILITY
FREQUENCY
Before each
use
After each use
Every 10 hours
MAINTENANCE
REQUIRED
=
Check for loose screws, nuts or bolts
(tighten as needed)
•
Check for damaged or worn parts*
Check the saw chain sharpness. Refer to
Sharpening the Saw Chain.
Test the chain brake*. Refer to Testing the
Chain Brake.
Check the chain tension (adjust as needed).
Refer to Adjusting the Chain Tension.
Fill the chain oil reservoir (refill frequently).
Refer to Adding Bar and Chain Off.
Fill the fuel tank with fresh, properly mixed
fuel. Refer to the Oil and Fuel section.
Clean the air filter. Refer to Maintaining the
Air Filter.
Clean the unit and inspect decals. Refer to
Cleaning in the Cleaning and Storage
section.
Check the spark plug condition and gap.
Refer to Maintaining the Spark Plug.
Clean the guide bar groove and oil
passages. Lubricate the sprocket tip. Refer
to Maintaining the Guide Bar.
Clean the cylinder fins. Refer to Cleaning in
the Cleaning and Storage section.
* If maintenance or replacement
is required, have the unit serviced
by a Sears or other qualified service dealer.
19
Publicidad
