Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING THE GUIDE BAR AND SAW CHAIN
WARNING:
Always use a low-kickback
saw chain,
which significantly
reduces the danger of kickback. Low-
kickback saw chain does not completely eliminate
kickback. A low-kickback
or "safety chain," should never
be regarded as total protection against injury.
When replacing the guide bar and saw chain, only use the
replacement
parts specified by the manufacturer
or their
equivalents. Refer to Replacement Parts. Use of any unauthorized
parts or accessories could lead to serious injury to the operator or
damage to the unit and will VOiD the warranty.
Always use a replacement saw chain designated
as "low-kickback"
or a saw chain that meets the low-kickback
performance
requirements. A standard saw chain (a chain that does not have the
kickback-reducing
guard links) should only be used by an
experienced
professional chain saw operator.
Lubrication Hole
Guide Bar Tip Lube Gun
Fig. 41
Guide Bar Sprocket
Tip
MAiNTAiNiNG
THE AiR FILTER
WARNING:
To avoid serious personal injury, always stop
the engine and allow it to cool before cleaning or maintaining
J
the unit.
Failure to maintain the air filter can result in poor performance
or
can cause permanent damage to the engine. Engine failure due to
improper air filter maintenance is not covered by the product warranty.
Cleaning
the Air Filter
1. Turn the knob on the air filter cover counterclockwise
to loosen
the air filter cover (Fig. 42).
2. Remove the air filter cover (Fig. 42).
3. Remove the air filter (Fig. 43).
4. Wash the air filter in mild detergent and water. Rinse the air filter
thoroughly
and allow it to dry.
5. Reinstall the air filter onto the mounting post (Fig. 43). Make sure
the opening in the air filter sits securely in the air intake (Fig. 43).
NOTE: Operating the unit without the air filter and air filter cover will
VOiD the warranty. Keep a supply of spare air filters.
6. Place the air filter cover back onto the unit. insert the tab on the
air filter cover into the slot on the chain saw housing (Fig. 42).
7. Turn the knob clockwise to tighten the air filter cover securely.
Tab
Knob
Air Filter _
Cover
Air Filter
Fig. 42
Slot
Mounting
Post
Air Intake
Fig. 43
25
Publicidad
