Descargar Imprimir esta página

Craftsman 917.28810 Manual Del Operador página 23

Publicidad

Idiomas disponibles

Idiomas disponibles

_b
ARNING:
TO AVOID SERIOUS
INJURY, BEFORE PERFORMING
ANY
SERVICE
OR ADJUSTMENTS:
1. Depress clutch/brake
pedal fully and set parking brake.
2.
Place motion control lever in neutral position.
3.
Place attachment
clutch
in "DISENGAGED"
position.
4. Turn ignition key to "STOP" and remove key.
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect
spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TO REMOVE
MOWER
Mower will be easier to remove from the
right side of tractor.
1. Place attachment
clutch in "DISEN-
GAGED" position.
2. Move attachment
lift lever forward to
lower mower to its lowest position.
3. Roll belt off engine pulley.
4. Remove small retainer spring, and
remove clutch spring off pulley bolt.
5. Remove large retainer spring, slide
collar off and push housing guide out
of bracket.
6. Disconnect
anti-sway
bar from chassis
bracket by removing retainer spring.
7. Disconnect
suspension
arms from rear
deck brackets by removing retainer
springs.
8. Disconnect
front links from deck by
removing retainer springs.
9. Raise lift lever to raise suspension
arms. Slide mower out from under
tractor.
IMPORTANT:
If an attachment
other than
the mower deck is to be mounted on the
tractor, remove the front links and hook
the clutch spring Into square hole in frame.
TO INSTALL
MOWER
1.
Raise attachment
lift lever to its highest
position.
2.
Slide mower
under
tractor
with deflec-
tor shield
to right side of tractor.
3.
Lower
lift lever to its lowest
position.
4.
Connect
front links to mower
deck and
secure
with retainer
springs.
5.
Connect
suspension
arms to rear
deck brackets
and secure
with retainer
springs.
6.
Connect
anti-sway
bar to chassis
bracket
and secure
with retainer
spring.
7.
Push clutch
cable
housing
guide
into
bracket,
slide
collar
onto guide and
secure
with large
retainer
spring.
8.
Place flat washer
and clutch
spring
on
idler pulley
bolt and secure
with small
retainer
spring.
9.
Install
belt onto engine
pulley.
Small Retainer Spring
Clutch Spring
Small Retainer
Clutch
S
Igme
Pulley
Retainer
Spring
Front Link
Anti-Sway
Bar
\
Retainer Springs
(Both Sides)
Deflector
Housing
Guide
Retainer Spring
23

Publicidad

loading