To change the sound levels during playback
After adjusting
the balance
with the noise sequencer,
the SOUnCf
levels of the center or surround
speakers
can
be
adjusted
during
playback
of laser
discs or video software.
1
Press the MANUAL SELECT (TEST) button on the remote
control
repeatedly
to select
"CEN"
(center)
or "SLJF?"
(surround).
2
While
the "CEN" or "SUR is displayed, press the DOWN 11<4 ~~
or UP FM button on the remote control to adjust the volume.
a!
ADDITIONAL
DOLBY PRO LOGIC MODES
In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 CH LOGIC modes,
PHANTOM mode: Use this mode when no center speaker is
connected.
The center channel signals are output through the
left and right speakers.
3 CH LOGIC mode: Use this mode when no surround speakers
are connected. This mode reproduces rear sounds through the
front speakers.
If the surround speakers level of the SURROUND is changed
(see pa!]e 7), that of the DOLBY PRO LOGIC is also changed.
About the channels
The left and right speakers create the stereo effect.
The center speaker helps achieve precise sound positioning
over a broad sound field.
The rear-mounted surround speakers enhance the "depth" of
the sound field.
To chi~nge the delay time
The surround speakers reproduce sounds a split second after
the front
speakers,
The delay
is initially
set to 21 ms
(milliseconds),
To change this standard delay time, press the MANUAL SELECT
(TEST) button on the remote control repeatedly until "TIME is
displayed. Then, press the DOWN K
or UP W
button. Each
time olne of the buttons is pressed, the delay time changes as
shown below.
15MS+21MS~30MS
To select PHANTOM or 3 CH LOGIC
Press the DOLBY PRO LOGIC button repeatedly until the desired
Dolby Pro Logic mode is displayed. The Dolby Pro Logic mode
is displayed cyclically as follows,
~
NORMAL+
PHANTOM -*
3 CH LOGIC ,
To adjust the balance of connected speaker sound Ievells
Carry out steps 2 to 4 on page 17.
PLAY WITH DOLBY PRO LOGIC
m
" Depending on the sound source and/or listening conditions, a
m
surround effect may not be obtained even when the DOLBY
DOLBY PRO LOGIC
PRO LOGIC is on. -
The full DOLBY PRO LOGIC effect cannot be obtained vvhen
using software without DO~OOL~
SURROUNDI
mark. In this case, use
the SURROUND system instead. (See page 7.)
DOLBY
PRO LOGIC
1 Pre!ss the VIDEO/AUX
button and start playback
of the video source.
2 Press the DOLBY
PRO LOGIC
button.
NCWiMALis selected, and the playback sound has the DOLBY
PFio LOGIC effect.
To camcel Dolby Pro Logic mode
Press the DOLBY PRO LOGIC button repeatedly until P-OFF is
displayed.
ENGLISH 18