Publicidad
Idiomas disponibles
Idiomas disponibles
CASTER SYSTEM
(Not standard with all models)
Follow the instructions for the caster system that came with your vacuum.
CASTER SYSTEM ASSEMBLY
You will find four casters, four caster feet and four screws with your wet/dry vacuum.
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down so that bottom
is facing up.
2. With tank drain facing you, take caster feet marked with the lettter A and place in slots on left front and
right rear of tank also marked with the letter A. Secure with screws provided.
3. Take caster feet marked with the letter B and place in slots on right front and left rear of tank also
marked with the letter B. Secure with screws provided.
4. If flat washers are included in hardware package place flat washer over stem of caster before installing
casters into feet. NOTE: Flat washers are not required with all units.
5. Insert casters into feet by placing stem of caster into holes provided. Apply pressure and twisting motion
until casters snap into place. Return tank to upright position.
PLASTIC TANK WITH REAR CASTER DOLLY
You will find four casters, two caster feet, one dolly and four screws with your
wet/dry vacuum.
Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn
tank upside down so that the bottom is facing up.
2. Take rear caster dolly and place into slots (on rear of tank, opposite of
inlet) and secure with screws provided.
3. If flat washers are included in hardware package place flat washer over stem of
caster before installing casters into feet and dolly. NOTE: Flat washers are not
required with all units.
4. Insert casters into bottom of rear caster dolly by placing stem of caster into holes
provided. Apply pressure and twisting motion until casters snap into place.
ASSEMBLY
Publicidad
