Publicidad
Idiomas disponibles
Idiomas disponibles
6. With tank drain facing you, take caster foot marked with the
letter A and place in slot on left side of tank also marked with
the letter A and secure with screw provided.
7. Take caster foot marked with the letter B and place in slot on
right side of tank also marked with the letter B and secure with
screw provided.
8. If flat washers are included in hardware pack place flat washer over stem of caster before installing
casters into feet. NOTE: Flat washers are not required with all units.
9. Insert casters into feet by placing stem of caster into holes
provided. Apply pressure and twisting motion until casters snap into place.
10. Return tank to upright position.
INSTALLING THE CARRIAGE HANDLE
(Not standard with all models)
Stand vacuum right side up. Place metal carriage handle outside of tank
and under the side carrying handles. Be sure to spread the ends of the
carriage handles when assembling to prevent damage to the tank. Align
holes of carriage handle to holes in tank and fasten tightly with screws,
washers, and nuts provided. The sealing washer and screw have a close
fitting tolerance. Rubber side of sealing washer should fit against inside
wall of tank. Failure to properly install rubber washer could result in water
leakage or loss of performance. Replace the tank cover and clamp the lid
latches securely.
HOSE HOLDER INSTALLATION
(Not standard with all models)
If not already installed, assemble as follows:
1. With rear of unit facing you, take hose holder and position it with tabs facing rear of
unit.
2. Place "J" shaped tabs into the slots on cord wraps. Press down until tabs snap into
place.
3. Press down on center of hose holder until tab latches on bottom of tank cover.
PAGE 7
Publicidad
