Publicidad
Idiomas disponibles
Idiomas disponibles
1. Refer to the filter installation and maintenance section to make sure the correct filters are installed for
your cleaning operation.
2. Replace tank cover and apply pressure with thumb to each latch until it snaps tightly into place. Make
sure each latch is clamped securely.
3. Insert machine hose end with locking-nut into inlet located on the front of the tank.
Turn locking nut to tighten. Do not over-tighten.
4. Attach the extension wands to the accessory end of the hose. Twist the wands slightly at each
connection to secure them into place. NOTE: If an elbow grip (not standard on all models) has been
included with your vacuum, it can be placed between the accessory end of hose and the extension
wands for a more comfortable hand grip.
5. Attach one of the cleaning accessories (depending on your cleaning requirements) onto the extension
wands. Twist the accessory slightly to tighten the connection. NOTE: Many more useful tools are
available at your local dealer or the Shop-Vac
6. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF
FILTER INSTALLATION AND MAINTENANCE
DRY PICK UP OPERATION
NOTE: Never use the vacuum for dry pick up without a dry use filter installed. Using the vacuum without a
filter will cause dust to discharge from the blower port and cause damage to the motor.
WARNING
BEFORE REMOVING THE TANK COVER.
Follow the instructions for the filter that came with your vacuum. Some filters mentioned do not come
standard with all vacuums. Additional filters are available at your local dealer or the Shop-Vac
CARTRIDGE FILTER
The cartridge filter can be used for dry pick up and small quantities of wet pick up. Installation is the same
for both. When picking up fine dust or powders a high efficiency filter bag must be used with the cartridge
filter.
If a foam sleeve is installed on the lid cage, remove it by sliding it off the lid cage. NOTE: If the cartridge
1
filter has been used for wet pick up, it must be cleaned and dried before using it for dry pick up.
2. With the tank cover in an upside down position, slide the cartridge down over the lid
cage, pushing until the filter seals against the cover.
. Place the filter retainer into the top of the cartridge filter. Hold the tank cover with one
3
hand, turn the handle on the filter retainer clockwise to lock the filter into place.
4. To remove the filter for cleaning, hold the tank cover and turn the filter retainer
counter-clockwise to loosen and remove.
PAGE 8
SET UP AND OPERATION
–
ALWAYS DISCONNECT THE PLUG FROM THE WALL OUTLET
®
website.
®
website.
Publicidad
