Autoadapt Turny Low Vehicle Manual De Instalación página 30

30
Turny Low Vehicle Getting seated
11. Program Turny Low Vehicle
11.1
Activate the programming menu
Hold down the yellow button until
the Enter Code screen is shown. Then
enter the code 1, 2, 3, 4
11.2
Program movement paths
Turny Low Vehicle has three motors, one each for lengthwise, swivel and extension.
These motors must be programmed to create two separate movement paths for the
seat, a Comfort and a Swivel Out.
The movement path Comfort is the lengthwise path that the seat follows when the car
door is closed. The swivel out movement path combines the swivel and extension paths
the seat follows when the car door is open. Program the path as close to the B pillar as
possible. The programmed path can vary by +/- 5 mm. Program with an approx. 15 mm
margin to prevent damage to the product and car.
For many reasons it is a good idea to program as few operations as
possible. Use Stepless Swivel Out first to achieve a smooth, speedy
movement path.
When first programming it can be difficult to achieve the optimal
path. To edit a path, save it and exit programming mode. Run the
unit back to its home position and then run it to the point from
which you wish to edit the path. Enter programming mode, make the
desired changes and save.
Program movement path, comfort
1
2
Press 2 for forwards until screen 2 comes up.
Press 4 for Backwards until screen 3 comes up.
B pillar