Autoadapt Turny Low Vehicle Manual De Instalación página 32

32
Turny Low Vehicle Getting seated
Edit movement path, comfort
The front end position allows you to edit and save separately, steps 11-15. To edit
and save the rear end position, steps 16-17, editing of the front end position is
required first.
11
12
13
14
15
16
17
Run the seat in normal operating mode and swivel the seat fully into the car.
Activate the programming menu Hold down the yellow button in the middle of
the hand-held control until the enter code screen is shown. Then enter the code 1,
2, 3, 4
(Screen 12 comes up)
Press 2 for forwards until screen 13 comes up.
Press 4 for Backwards until screen 14 comes up.
Use 2 and 4, "forwards" and "backwards", to run to the desired front end position.
(When screen 15 comes up it is possible to save the new end position)
Alternative A - Press 1 to "save" and exit from the programming mode.
Turny Low Vehicle is now back in normal operating mode.
Alternative A - Press 3 to "save and continue" and program rear end position.
(Screen 16 comes up)
Use 2 and 4, and
Forwards Backwards,
(When screen 17 comes up it is possible to save the new end position)
The rear end position must be programmed behind the starting position for Swivel
Out. If the end position is programmed in front of the starting point, it will not be
possible to manoeuvre the seat and the programming must be done again.
Rear end position
"comfort"
Press 1 to Save and exit from the programming mode.
Turny Low Vehicle is now back in normal operating mode.
to run to the desired rear end position.
Movement path "swivel out"
Starting point Swivel Out
This starting position was previously
marked with a piece of tape in the
programming.