Edit movement path, swivel out
18
19
12. Update the software
A new hand-held control with the new program version is required to update the
software in the unit. Open the car door where Turny Low Vehicle is installed and
make sure that the hand-held control lights up. Replace the existing hand-held control
with the new one. The door will be open until step 3 below.
1
2
3
4
5
6
7
8
It is possible to begin editing from any point on the path. If the first part of the
programming is good you do not need to program the whole path. Swivel out in
normal operating mode to the point from which new programming is preferred
to be done. Activate the programming menu Hold down the yellow button in the
middle of the hand-held control until the enter code screen is shown. Then enter
the code 1, 2, 3, 4
Press 2 for Continue. Then program the new swivel and extender, see screens 8-10.
Press 1 to undo and cancel.
Press 4 to go straight into the emergency operation menu.
Activate the programming menu. Hold down the yellow button in the middle of
the hand-held control until the enter code screen is shown. Then enter the code
4, 3, 2, 1.
(Screen 2 comes up)
Press 2 to undo and cancel.
Press 4 to commence updating.
Updating in progress.
Updating is finished
Close the door and open again.
If Turny Low Vehicle is installed on the right side of the car, movement path pro-
gramming may begin; see Chapter 11. If Turny Low Vehicle is installed on the left
side of the car, inform the system of this; see next step below.
Hold down the yellow button in the middle of the hand-held control until the enter
code screen is shown. Then enter the code 1, 1, 1, 3
Press 4 for "continue" installation.
Press 3 for "OK".
(Screen 8 comes up)
Start programming of movement paths, see Chapter 11. Note that the choice of
installation "left" is only saved if programming is done in direct connection to the
choice. If this is not done in direct connection you must go in and select the "left"
installation again.
Getting seated Turny Low Vehicle
(Screen 5 comes up)
(Screen 7 comes up)
33
EN