Publicidad
Idiomas disponibles
Idiomas disponibles
Make sure there is a power outlet nearby and that the power cord is not
in a position that could constitute a tripping hazard. When connected to
the mains, the power supply unit must be within easy reach of the user.
Do not cover the power unit and do not apply pressure to it.
2. Insert the plug in the power socket. The display shows "50" for
approximately 1 second.
3. Press the key
for 2 seconds to turn on the device. The pre-set
parameters are: temperature level 3, timer 3 hours.
4. Press the keys
to set the temperature.
5. Press the key
to set the automatic switch-off time (1-10 hours);
If a temperature level from 5 to 10 and a switch-off time greater than 3
hours are set, the temperature will be lowered to level 4 after 3 hours of
operation for safety reasons.
WARNING: Select a comfortable temperature level. For continuous
and prolonged use of the appliance, for example by a user who may
fall asleep, set the control unit to position 1 to avoid skin burns or
heat stroke.
6. At the end of the automatic switch-off time, the heating is stopped and
the appliance goes into "standby" mode (the display shows "- -").
7. Press the key
for 1 second to switch off the appliance.
8. After use, remove the plug from the power socket.
ATTENTION: do not leave the control unit under the blanket, wrapped in
the blanket or on top of the blanket while it is turned on.
ATTENTION: Do not leave the blanket folded or creased while it is on.
The appliance is equipped with a protection system against overheating
(see the table below).
21 / 72
Publicidad
